Art Controller Relay Board Kit

The Art Controller is a multitalented, stand-alone relay module with microcontroller based timing and logic. Easier to adjust and more versatile than most other low-cost time-delay relay modules, the Art Controller can switch AC or DC loads and is reprogrammable to handle the…

Relay COM
Common terminal of the SPDT relay output terminal block. Adafruit says COM is connected to NC when idle and to NO when the coil is energised.
Type · switchVoltage · Recommended load rating 24 V DC / 40 VAC, 5 A; NO contact 10 A only, per Adafruit product page.
Relay NC
Normally-closed relay terminal. Connected to COM when the relay coil is idle or power is removed, per Adafruit product page.
Type · switchVoltage · Relay contact load terminal, see COM rating.
Relay NO
Normally-open relay terminal. Connected to COM when the relay coil is energised, per Adafruit product page.
Type · switchVoltage · Relay contact load terminal, see COM rating; Adafruit notes 10 A normally-open only.
Trigger input
Two-pin trigger input for a normally-open button/switch or external low-going logic signal; closing the two trigger pins starts the controller cycle.
Type · digitalVoltage · Logic/input terminal; product page says low-going signal is perceived like a button press.
Input power

Start wiring

Recommended load rating 24 V DC / 40 VAC, 5 A; NO contact 10 A only, per Adafruit product page. · Relay contact load terminal, see COM rating.

Verify supply voltage and logic levels before powering up.

Module pins: Input power. Schematik maps them to your board in the app.

Related groups

4 groups

Connectors

Sort passive connector adapters from Qwiic boards, LCD modules and microSD card adapters before assuming anything with the right plug will substitute safely.

Connectors & cables · Connectors · 28 parts

Displays

Character LCDs, SPI TFTs, e-paper modules and larger capacitive-touch TFT panels solve different display jobs. Treat display class, interface, controller, resolution, touch, refresh behaviour, storage, voltage and mounting as separate swap checks.

Displays · TFT & LCD displays · 35 parts

Air quality

Choose between MQ gas sensors, VOC/eCO2 indoor-air sensors, true CO2 modules and particulate sensors without treating every air-quality breakout as the same detector.

Sensors · Gas & air-quality sensors · 31 parts

MCUs and boards

ESP32, Arduino Uno, Raspberry Pi Pico, and compatible add-on boards for running builds.

Boards · Microcontroller boards · 24 parts