32x32 RGB LED Matrix Panel - 5mm Pitch

Bring a little bit of Times Square into your home with this sweet 32 x 32 square RGB LED matrix panel. These panels are normally used to make video walls, here in New York we see them on the sides of busses and bus stops, to display animations or short video clips.

R1
HUB75 red data for the upper half of the RGB matrix panel; Adafruit matrix wiring guide names R1/G1/B1 as upper-half colour data.
Type · signal
G1
HUB75 green data for the upper half of the RGB matrix panel.
Type · signal
B1
HUB75 blue data for the upper half of the RGB matrix panel.
Type · signal
R2
HUB75 red data for the lower half of the RGB matrix panel.
Type · signal
G2
HUB75 green data for the lower half of the RGB matrix panel.
Type · signal
B2
HUB75 blue data for the lower half of the RGB matrix panel.

Start wiring

SPI · 5 V panel supply

Verify supply voltage and logic levels before powering up.

Module pins: 5V, GND, R1, G1, B1, R2, G2, B2. Schematik maps them to your board in the app.

Related groups

4 groups

Displays

Character LCDs, SPI TFTs, e-paper modules and larger capacitive-touch TFT panels solve different display jobs. Treat display class, interface, controller, resolution, touch, refresh behaviour, storage, voltage and mounting as separate swap checks.

Displays · TFT & LCD displays · 35 parts

Connectors

Sort passive connector adapters from Qwiic boards, LCD modules and microSD card adapters before assuming anything with the right plug will substitute safely.

Connectors & cables · Connectors · 28 parts

Air quality

Choose between MQ gas sensors, VOC/eCO2 indoor-air sensors, true CO2 modules and particulate sensors without treating every air-quality breakout as the same detector.

Sensors · Gas & air-quality sensors · 31 parts

MCUs and boards

ESP32, Arduino Uno, Raspberry Pi Pico, and compatible add-on boards for running builds.

Boards · Microcontroller boards · 27 parts

Pin	Type	Function	Voltage
R1	signal	HUB75 red data for the upper half of the RGB matrix panel; Adafruit matrix wiring guide names R1/G1/B1 as upper-half colour data.
G1	signal	HUB75 green data for the upper half of the RGB matrix panel.
B1	signal	HUB75 blue data for the upper half of the RGB matrix panel.
R2	signal	HUB75 red data for the lower half of the RGB matrix panel.
G2	signal	HUB75 green data for the lower half of the RGB matrix panel.
B2	signal	HUB75 blue data for the lower half of the RGB matrix panel.
A	signal	Row address select signal for the RGB matrix panel.
B	signal	Row address select signal for the RGB matrix panel.
C	signal	Row address select signal for the RGB matrix panel.
D	signal	Row address select signal for the 32-row RGB matrix panel.
CLK	signal	HUB75 clock input for clocking RGB data to the matrix.
LAT / STB	signal	HUB75 latch/strobe input; Adafruit notes LAT may be labelled STB on some panels.
OE	signal	HUB75 output-enable input controlling whether the LEDs are lit.
5V	power	Panel power input for LED matrix power.	5 V panel supply
GND	ground	Panel ground; Adafruit guide notes ground pins may be unlabeled but must be connected.

Pinout

Start wiring

Displays

Connectors

Air quality

MCUs and boards