Gravity: DHT11 Temperature & Humidity Sensor For Arduino

Gravity: DHT11 Temperature & Humidity Sensor For Arduino — DFRobot — DFR0067
Availability
In stock

DHT11 digital temperature and humidity sensor breakout compatible with Arduino and Raspberry Pi. Single-wire protocol; low power consumption and plug-and-play Gravity connector.

Pinout

Logical pinout · physical placement not verified
GRAVITY: DHT11 TEMPERAVCCDATAGND
  • VCC
    Type · PowerVoltage · 3.3
  • GND
    Type · Ground
  • DATA

    Single-wire data pin

    Type · Signal

Start wiring

I2C · SPI · Single data line · 3.3 – 5 V · Breakout

Confirm the data interface matches your host board.

Module pins: VCC, GND, DATA. Schematik maps them to your board in the app.

Temp & humidity

165 other options

DHT/AHT sensors, SHT-series humidity chips, BMP and LPS barometers, BME combined sensors, DS18B20 probes, thermocouple amplifiers and non-contact MLX IR sensors — about 165 listings, very different accuracy classes.

View all 165

Related groups

4 groups