Adafruit I2C to 8 Channel Solenoid Driver

Adafruit I2C to 8 Channel Solenoid Driver — Adafruit — 6318
Availability
Out of stock

I2C breakout (STEMMA QT / Qwiic) that drives up to eight solenoids via MOSFET outputs using an MCP23017 GPIO expander. Additional GPIO pins are broken out on a lower header row for general use.

Pinout

Logical pinout · physical placement not verified
ADAFRUIT I2C TO 8 CHANVccSolenoid outputs +V+V++B0-B7 GPIO rowGNDINTGND padsRed LEDSCLGreen LEDsSDALED jumperSTEMMA QT connectorsAddress jumpers

One grouped source record is expanded into separate logical pads where unambiguous; physical placement is not implied.

  • Vcc
    Type · Power
  • V++
    Type · Power
  • GND
    Type · Ground
  • GND pads
    Type · Ground
  • SCL
    Type · I2C
  • SDA
    Type · I2C
  • STEMMA QT connectors
    Type · I2C
  • Solenoid outputs +V+
    Type · Power
  • Solenoid outputs 0-7A0-A7
    Type · USB
  • B0-B7 GPIO row
    Type · GPIO
  • INT
    Type · Signal
  • Red LED
    Type · Unknown
  • Green LEDs
    Type · Unknown
  • LED jumper
    Type · Unknown
  • Address jumpers
    Type · Unknown

Start wiring

PWM · I2C · UART · Wide input · Breakout

Confirm the data interface matches your host board.

Module pins: Vcc, GND, GND pads, SCL, SDA, B0-B7 GPIO row. Schematik maps them to your board in the app.

Motor drivers

76 other options

H-bridge breakouts from 1A to 43A (DRV8871, TB6612FNG, BTS7960), stepper drivers (A4988, TMC260, TB6600), I2C servo/solenoid controllers, and Pi/Arduino shields — sized by current and protocol.

View all 76

Related groups

4 groups