TMP235 Plug-and-Play STEMMA Analog Temperature Sensor

TMP235 Plug-and-Play STEMMA Analog Temperature Sensor — Adafruit — 4686

TMP235 analog temperature sensor with 3-pin JST STEMMA connector. Outputs a voltage proportional to temperature — requires a microcontroller ADC input, not I2C.

Pinout

Logical pinout · physical placement not verified
TMP235 PLUG-AND-PLAY SRed wireVINWhite wireOUTBlack wireGND
  • Red wireVINred wire

    3-pin JST PH cable red wire connects to 3V to 5V DC power, per Adafruit product page.

    Type · PowerVoltage · 3V to 5V DC
  • Black wireGNDblack wire

    3-pin JST PH cable black wire connects to ground, per Adafruit product page.

    Type · GroundVoltage · 0V
  • White wireOUTwhite wire

    3-pin JST PH cable white wire connects to an analog input; voltage output is 0V at -50°C and 1.75V at 125°C, per Adafruit product page.

    Type · AnalogVoltage · 0V at -50°C to 1.75V at 125°C output

Start wiring

I2C · SPI · Single data line · 3.3 – 5 V · Breakout

Confirm the data interface matches your host board.

Module pins: Red wire / VIN, Black wire / GND, White wire / OUT. Schematik maps them to your board in the app.

Temp & humidity

165 other options

DHT/AHT sensors, SHT-series humidity chips, BMP and LPS barometers, BME combined sensors, DS18B20 probes, thermocouple amplifiers and non-contact MLX IR sensors — about 165 listings, very different accuracy classes.

View all 165

Related groups

4 groups