USB-C SMT/THM Jack Connector, Power Only - Pack of 10

Pack of 10 USB Type-C power-only jack connectors with four through-hole mounting tabs and SMT-solderable pads. Carries power only (no data lines); tabs can be pasted over in SMT reflow or soldered through-hole for mechanical strength.

Logical pinout · physical placement not verified

GND
USB-C connector ground pins; Adafruit states there are two ground pins on this power-only connector.
Type · GroundVoltage · 0V reference
VBUS
USB-C bus power pins; Adafruit states there are two VBUS power pins for getting 5V power from a USB port.
Type · PowerVoltage · 5V from USB port
CC1
USB-C configuration-channel pin; Adafruit says to tie CC1 to ground with a 5.1K resistor for power-sink use.
Type · Control
CC2
USB-C configuration-channel pin; Adafruit says to tie CC2 to ground with a 5.1K resistor for power-sink use.
Type · Control

Pin	Type	Function	Voltage
GND	Ground	USB-C connector ground pins; Adafruit states there are two ground pins on this power-only connector.	0V reference
VBUS	Power	USB-C bus power pins; Adafruit states there are two VBUS power pins for getting 5V power from a USB port.	5V from USB port
CC1	Control	USB-C configuration-channel pin; Adafruit says to tie CC1 to ground with a 5.1K resistor for power-sink use.
CC2	Control	USB-C configuration-channel pin; Adafruit says to tie CC2 to ground with a 5.1K resistor for power-sink use.

Logical pinout · physical placement not verified

Pin details

4 connections

GND
USB-C connector ground pins; Adafruit states there are two ground pins on this power-only connector.
GroundVoltage · 0V reference
VBUS
USB-C bus power pins; Adafruit states there are two VBUS power pins for getting 5V power from a USB port.
PowerVoltage · 5V from USB port
CC1
USB-C configuration-channel pin; Adafruit says to tie CC1 to ground with a 5.1K resistor for power-sink use.
Control
CC2
USB-C configuration-channel pin; Adafruit says to tie CC2 to ground with a 5.1K resistor for power-sink use.
Control

Connectors

223 other options

Passive adapters, 2.54 mm pin headers, terminal blocks, JST and barrel-jack connector pairs, RF antennas and microSD adapters. Mechanical fit between two connectors does not confirm voltage, pinout or protocol compatibility.

View all 223

Related groups

4 groups

Cables

Around 250 entries: JST SH/PH cable pairs, Grove and STEMMA QT/Qwiic leads, jumper wires, silicone hookup wire from 30 AWG to 8 AWG, and FPC ribbon cables. Ecosystem bridge cables exist for the PH-to-SH pitch mismatch.

Connectors & cables · Cables & wires · 261 parts

USB and serial

Passive USB cables plus passive USB cables, Micro-B and USB-C breakouts, CP2102 and FT232 USB-UART bridges, DIY cable assembly parts, and USB-C development boards. Data support, host/device role and logic voltage vary significantly across the group.

Connectors & cables · USB cables · 91 parts

3D printing

DFRobot 1.75 mm PLA in 1 kg spools makes up the bulk of the group, in over 15 colors. Specialty options include PVA in both diameters, NinjaFlex flexible filament, Proto-Pasta conductive PLA, and wood-fill. OverLord printer spares and OverLord printers round out the hardware side.

Tools & prototyping · 3D printing · 53 parts

LED pixels

WS2812/SK6812 NeoPixel strips, rings and Jewels, APA102 DotStar pixels, and plain analog RGB strips — each matched to its protocol and host, not just its connector.

Components · Addressable LEDs · 180 parts