
FT232RL USB-to-serial breakout supporting 3.3V and 5V operation. Features auto-reset via DTR pin, TX/RX LEDs, and microUSB input; compatible with Arduino serial bootloading.
Ground reference on the standard FTDI-style 6-pin header; DFRobot states the BLK orientation label corresponds to the ground wire colour on standard FTDI cables.
Clear-to-send hardware flow-control signal on the standard FTDI cable-compatible 6-pin header described by DFRobot.
Selectable target/output supply pin on the FTDI breakout header.
USB-to-TTL serial transmit output from the FT232RL breakout; DFRobot describes TX serial activity and FTDI cable-compatible pinout.
74HC logic gates, MCP3008/MCP23017 ADCs and expanders, 24LC256 EEPROM, 4N25-series optocouplers and ULN2803A drivers — bare DIP chips with no breakout-board conveniences like pull-ups or level shifting.
10W Super Bright LED - Violet visual preview
10W Super Bright LED - Warm White visual preview
3-Pin LED Strip Connector Cable - Single Head (5PCS) visual preview
3-Pin LED Strip Connector Cable (5PCS) visual previewWS2812/SK6812 NeoPixel strips, rings and Jewels, APA102 DotStar pixels, and plain analog RGB strips — each matched to its protocol and host, not just its connector.
Components · Addressable LEDs · 176 parts
10-bit ADC (SPI) visual preview
2-Channel RS232 Module for Raspberry Pi Pico visual preview
4-Ch USB 3.2 Gen1 Hub (USB3.2-Gen1-HUB-4U) visual preview
6-in-1 USB to Serial Converter visual previewADS1115/MCP3421 ADCs, MCP4725 and GP8413 DACs, CP2102 USB-UART boards, and I2C plumbing like the LTC4316 address shifter — matched to bus, resolution and signal range.
Components · Interface converters · 115 parts
256MB Micro SD Memory Card visual preview
25LC256 256 Kbit SPI EEPROM visual preview
64 Mbit Serial Pseudo SRAM - PSRAM - 3.3V 133 MHz visual preview
8GB Class 10 SD/MicroSD Memory Card - SD Adapter Included visual preview24LC32/25LC256 EEPROM, I2C FRAM, 64Mbit PSRAM, and microSD breakouts up to 64GB — matched to write frequency and data volume, not just interface.
Components · Memory & storage · 39 parts
1/4W Resistor Pack - 400 PCS visual preview
1N4001 Diode - 10 pack visual preview
1N4007 Diode visual preview
1N4148 General Purpose Fast Switching Diode visual previewE12 resistor kits, ceramic and electrolytic capacitor sets, 1N4148/1N4007 diodes, TIP120 Darlingtons, IRLZ44N MOSFETs and 100F supercapacitors — bench stock in kit quantities.
Components · Passives · 56 parts
USB-to-TTL serial receive input to the FT232RL breakout; DFRobot describes RX serial activity and FTDI cable-compatible pinout.
DTR auto-reset signal exposed by the breakout; DFRobot states the GRN orientation label corresponds to the DTR wire colour on standard FTDI cables.
| Pin | Position | Type | Function | Voltage |
|---|---|---|---|---|
| GND / BLK | 1 | ground | Ground reference on the standard FTDI-style 6-pin header; DFRobot states the BLK orientation label corresponds to the ground wire colour on standard FTDI cables. | 0V |
| CTS | 2 | signal | Clear-to-send hardware flow-control signal on the standard FTDI cable-compatible 6-pin header described by DFRobot. | 3.3V or 5V TTL logic, selectable by jumper per DFRobot specification |
| VCC | 3 | power | Selectable target/output supply pin on the FTDI breakout header. | 3.3V or 5V output, switchable via jumpers per DFRobot specification |
| TXO | 4 | signal | USB-to-TTL serial transmit output from the FT232RL breakout; DFRobot describes TX serial activity and FTDI cable-compatible pinout. | 3.3V or 5V TTL logic, selectable by jumper per DFRobot specification |
| RXI | 5 | signal | USB-to-TTL serial receive input to the FT232RL breakout; DFRobot describes RX serial activity and FTDI cable-compatible pinout. | 3.3V or 5V TTL logic, selectable by jumper per DFRobot specification |
| DTR / GRN | 6 | signal | DTR auto-reset signal exposed by the breakout; DFRobot states the GRN orientation label corresponds to the DTR wire colour on standard FTDI cables. | 3.3V or 5V TTL logic, selectable by jumper per DFRobot specification |
18-Channel 8-bit PWM LED Driver w/ I2C Interface