Gravity: Digital PIR (Motion) Sensor for Arduino / Raspberry Pi

Digital PIR Motion Sensor detects infrared radiation for precise motion detection. It integrates easily with Arduino/Raspberry Pi, suitable for home automation.

DGravity PH2.0-3 signal pin
Digital motion output from the SEN0171 PIR sensor; DFRobot example wiring connects this output to Arduino digital pin 2, and the result text says it outputs about 3V high when motion is detected and 0V otherwise.
Type · signalVoltage · 0V low, about 3V high when triggered; module operates from 3.3V to 5V
VCCGravity PH2.0-3 power pin
Module supply input for the Gravity digital PIR motion sensor.
Type · powerVoltage · 3.3V to 5V
GNDGravity PH2.0-3 ground pin
Ground reference for module power and digital output.
Type · groundVoltage · 0V

Pin	Position	Type	Function	Voltage

Start wiring

0V low, about 3V high when triggered; module operates from 3.3V to 5V · 3.3V to 5V

Verify supply voltage and logic levels before powering up.

Module pins: VCC, GND, D. Schematik maps them to your board in the app.

Related groups

4 groups

Air quality

Choose between MQ gas sensors, VOC/eCO2 indoor-air sensors, true CO2 modules and particulate sensors without treating every air-quality breakout as the same detector.

Sensors · Gas & air-quality sensors · 29 parts

Temp and humidity

DHT11, DHT22/AM2302, and DHT20/AHT20 sensors solve the same broad job, but only some are acceptable substitutes in the same circuit.

Sensors · Environment sensors · 19 parts

Environment sensors

Choose between temperature-only, temperature/humidity, pressure and indoor air-quality modules without treating every environmental sensor as a drop-in substitute.

Sensors · Environment sensors · 8 parts

Light and colour

Photoresistors and color sensors both respond to light, but they expose very different signals and are not sensible drop-in substitutes.

Sensors · Light & color sensors · 6 parts

D	Gravity PH2.0-3 signal pin	signal	Digital motion output from the SEN0171 PIR sensor; DFRobot example wiring connects this output to Arduino digital pin 2, and the result text says it outputs about 3V high when motion is detected and 0V otherwise.	0V low, about 3V high when triggered; module operates from 3.3V to 5V
VCC	Gravity PH2.0-3 power pin	power	Module supply input for the Gravity digital PIR motion sensor.	3.3V to 5V
GND	Gravity PH2.0-3 ground pin	ground	Ground reference for module power and digital output.	0V

Pinout

Start wiring

Air quality

Temp and humidity

Environment sensors

Light and colour