Gravity: Triple Axis Accelerometer - MMA7361 (±1.5g/±6g) (Discontinued)

Triple Axis Accelerometer MMA7361 has selectable sensitivity, analog output, and requires additional hardware for digital conversion. It's discontinued.

XX-axis JST signal output
MMA7361 X-axis analogue output; DFRobot Arduino example reads the X axis on analogue input A5, and the schematic labels the sensor output Xout.
Type · analog
YY-axis JST signal output
MMA7361 Y-axis analogue output; DFRobot Arduino example reads the Y axis on analogue input A4, and the schematic labels the sensor output Yout.
Type · analog
ZZ-axis JST signal output
MMA7361 Z-axis analogue output; DFRobot Arduino example reads the Z axis on analogue input A3, and the schematic labels the sensor output Zout.
Type · analog
VCCJST power rail shared by the axis connectors
Board supply input for the DFRobot MMA7361 module; product specification gives a 3.3-8V operating/input range.
Type · powerVoltage · 3.3-8V input, regulated to 3.3V on board

Start wiring

Analog · 3.3-8V input, regulated to 3.3V on board · 0V

Verify supply voltage and logic levels before powering up.

Module pins: VCC, GND, X, Y, Z. Schematik maps them to your board in the app.

Related groups

4 groups

Air quality

Choose between MQ gas sensors, VOC/eCO2 indoor-air sensors, true CO2 modules and particulate sensors without treating every air-quality breakout as the same detector.

Sensors · Gas & air-quality sensors · 29 parts

Temp and humidity

DHT11, DHT22/AM2302, and DHT20/AHT20 sensors solve the same broad job, but only some are acceptable substitutes in the same circuit.

Sensors · Environment sensors · 19 parts

Environment sensors

Choose between temperature-only, temperature/humidity, pressure and indoor air-quality modules without treating every environmental sensor as a drop-in substitute.

Sensors · Environment sensors · 8 parts

Light and colour

Photoresistors and color sensors both respond to light, but they expose very different signals and are not sensible drop-in substitutes.

Sensors · Light & color sensors · 6 parts

Pin	Position	Type	Function	Voltage
X	X-axis JST signal output	analog	MMA7361 X-axis analogue output; DFRobot Arduino example reads the X axis on analogue input A5, and the schematic labels the sensor output Xout.
Y	Y-axis JST signal output	analog	MMA7361 Y-axis analogue output; DFRobot Arduino example reads the Y axis on analogue input A4, and the schematic labels the sensor output Yout.
Z	Z-axis JST signal output	analog	MMA7361 Z-axis analogue output; DFRobot Arduino example reads the Z axis on analogue input A3, and the schematic labels the sensor output Zout.
VCC	JST power rail shared by the axis connectors	power	Board supply input for the DFRobot MMA7361 module; product specification gives a 3.3-8V operating/input range.	3.3-8V input, regulated to 3.3V on board
GND	JST ground rail shared by the axis connectors	ground	Ground reference for supply and analogue axis outputs, shown on the DFRobot schematic.	0V

Pinout

Start wiring

Air quality

Temp and humidity

Environment sensors

Light and colour