Gravity: Digital Tilt Sensor for Arduino / Raspberry Pi

Arduino-compatible tilt sensor detects orientation via a ball inside. Works with Raspberry Pi, has a wide voltage range, and features a digital interface.

Input1
DFRobot wiki pinout lists this Gravity connector pin as Input; digital tilt sensor signal output used to detect orientation/tilt state.
Type · digital output
Power2
DFRobot wiki pinout lists this Gravity connector pin as Power for the sensor module.
Type · powerVoltage · module supply, exact range not stated on the cited pinout table
GND3
DFRobot wiki pinout lists this Gravity connector pin as GND.
Type · groundVoltage · 0V

Pin	Position	Type	Function	Voltage
Input

Start wiring

module supply, exact range not stated on the cited pinout table · 0V

Confirm the data interface matches your host board.

Module pins: Power, GND. Schematik maps them to your board in the app.

Related groups

4 groups

Air quality

Choose between MQ gas sensors, VOC/eCO2 indoor-air sensors, true CO2 modules and particulate sensors without treating every air-quality breakout as the same detector.

Sensors · Gas & air-quality sensors · 29 parts

Temp and humidity

DHT11, DHT22/AM2302, and DHT20/AHT20 sensors solve the same broad job, but only some are acceptable substitutes in the same circuit.

Sensors · Environment sensors · 19 parts

Environment sensors

Choose between temperature-only, temperature/humidity, pressure and indoor air-quality modules without treating every environmental sensor as a drop-in substitute.

Sensors · Environment sensors · 8 parts

Light and colour

Photoresistors and color sensors both respond to light, but they expose very different signals and are not sensible drop-in substitutes.

Sensors · Light & color sensors · 6 parts

Pinout

Start wiring

Air quality

Temp and humidity

Environment sensors

Light and colour