MCP4725 DAC Module
12-bit single-channel I2C DAC breakout with onboard EEPROM for storing the wiper setting across power cycles. Outputs 0V to VCC; I2C address 0x60 or 0x61 via ADDR pin. Compatible with 3.3V and 5V systems.
12-bit single-channel I2C DAC breakout with onboard EEPROM for storing the wiper setting across power cycles. Outputs 0V to VCC; I2C address 0x60 or 0x61 via ADDR pin. Compatible with 3.3V and 5V systems.
3.3V supply input
Ground reference
I2C data line — connect to ESP32-S3 SDA (shared I2C bus)
I2C clock line — connect to ESP32-S3 SCL (shared I2C bus)
Analog voltage output 0–VCC (0–3.3V); feed to op-amp scaling stage for 0–10V range
I2C address select pin; tie to GND for 0x60, tie to VCC for 0x61
| Pin | Type | Function | Voltage |
|---|---|---|---|
| VCC | Power | 3.3V supply input | 3.3 |
| GND | Ground | Ground reference | |
| SDA | I2C | I2C data line — connect to ESP32-S3 SDA (shared I2C bus) | |
| SCL | I2C | I2C clock line — connect to ESP32-S3 SCL (shared I2C bus) | |
| OUT | Analog | Analog voltage output 0–VCC (0–3.3V); feed to op-amp scaling stage for 0–10V range | |
| ADDR | GPIO | I2C address select pin; tie to GND for 0x60, tie to VCC for 0x61 |
3.3V supply input
Ground reference
I2C data line — connect to ESP32-S3 SDA (shared I2C bus)
I2C clock line — connect to ESP32-S3 SCL (shared I2C bus)
Analog voltage output 0–VCC (0–3.3V); feed to op-amp scaling stage for 0–10V range
I2C address select pin; tie to GND for 0x60, tie to VCC for 0x61
E12 resistor kits, ceramic and electrolytic capacitor sets, 1N4148/1N4007 diodes, TIP120 Darlingtons, IRLZ44N MOSFETs and 100F supercapacitors — bench stock in kit quantities.
1/4W Resistor Pack - 400 PCS visual preview1/4W Resistor Pack - 400 PCS
1N4001 Diode - 10 pack visual preview1N4001 Diode - 10 pack
1N4007 Diode visual preview1N4007 Diode
1N4148 General Purpose Fast Switching Diode visual preview1N4148 General Purpose Fast Switching Diode
220 Ω Metal Film Resistors, 1/4 W (Pack of 10) visual preview220 Ω Metal Film Resistors, 1/4 W (Pack of 10)
3mm LED Blue - 25 PCs visual preview3mm LED Blue - 25 PCs
3mm LED Pack (50 PCS) visual preview3mm LED Pack (50 PCS)
5mm Green LED visual preview5mm Green LED
5mm LED Pack (6 PCS) visual preview5mm LED Pack (6 PCS)
6-Ch High Current Driver 1X3 Kit v1 visual preview6-Ch High Current Driver 1X3 Kit v1
74HC165 Parallel-In Serial-Out Shift Register visual preview74HC165 Parallel-In Serial-Out Shift Register
74HC4067 16-Channel Analog Multiplexer visual preview74HC4067 16-Channel Analog Multiplexer
10W Super Bright LED - Violet visual previewWS2812/SK6812 NeoPixel strips, rings and Jewels, APA102 DotStar pixels, and plain analog RGB strips — each matched to its protocol and host, not just its connector.
Components · Addressable LEDs · 180 parts
18-Channel 8-bit PWM LED Driver w/ I2C Interface visual preview74HC logic gates, MCP3008/MCP23017 ADCs and expanders, 24LC256 EEPROM, 4N25-series optocouplers and ULN2803A drivers — bare DIP chips with no breakout-board conveniences like pull-ups or level shifting.
Components · Integrated circuits · 68 parts
10-bit ADC (SPI) visual previewADS1115/MCP3421 ADCs, MCP4725 and GP8413 DACs, CP2102 USB-UART boards, and I2C plumbing like the LTC4316 address shifter — matched to bus, resolution and signal range.
Components · Interface converters · 114 parts
256MB Micro SD Memory Card visual preview24LC32/25LC256 EEPROM, I2C FRAM, 64Mbit PSRAM, and microSD breakouts up to 64GB — matched to write frequency and data volume, not just interface.
Components · Memory & storage · 39 parts